You can configure the LiBase to broadcast a local NTRIP network, which you can use for RTK on DJI Drones
1. Enable WiFi on the Libase by pressing the power button until the settings menu comes up, then scroll down using the arrow button and press the power button again and select WiFi > Enable
2. Connect to your LiBase WiFi on a computer. The network name will be LiBase-{Serial Number of your LiBase}. The password will be 12345678
3. Go to the address 192.168.1.8 on your browser
4. Click on Configuration > Antenna Setup. Set the vertical height of your antenna and click enter
5. Click on Base Station Configuration, and set the station ID as any number you like. If your LiBase is setup over a known point, enter the coordinates. If not, then click on Get position. Then click Start
- If you refresh the page, the Status field on Base Station Configuration should be Started
6. Click on Work Mode. Then on the NTRIP Server row click on Setup. A new window will come up, once it does click next
7. A new window "Port Configuration" will come up. Use the following settings:
- Dropdown: NTRIP Server
- Use: Checked
- Ntrip Version: V2.0
- CasterAddress: 192.168.1.8 port 12345
- Username: {anything you like}
- Password: {anything you like}
- Mountpoint: {Serial number of your LiBase}
- Data Stream: RTCM3.2
Click Enter
8. Click on Receiver Management > Data Transfer
On the TCP1/WEBNTRIP1 row, it should be green and be set to the port we set previously. On this row, click Setup
9. A new window will come up "Port Configuration". Set the following options:
- Dropdown: TCP1/WEBNTRIP1
- Use: Checked
- Work Mode: WEBNTRIP
- IP: 192.168.1.8
- Port: 12345
- Mount point: {Serial Number of your LiBase}
- Data Stream: RTCM3.2
Click Enter
10. On DJI Pilot, navigate to the RTK settings
11. Turn on RTK Positioning. Set RTK Service type to Custom Network RTK. In the settings that come up, use this information:
- NTRIP Host: 192.168.1.8
- Port: 12345
- User: {Username you entered before}
- Password: {Password you entered before}
- Mountpoint: {Serial number of your LiBase}
Click Save
12. If everything is connected properly, you should see the RTK Status as Connected and RTK data in use. You may need to restart your drone/LiBase.